Securing in place with a securing plate and a thread stud (all types of guides)

1. Attach the guide to the installation place of the car saloon interior.
2. Do the spacing on the saloon interior through the holes in the guide.
3. Drill the holes according to the made spacing.
4. Put the securing plates with the thread studs into the guide opposite each hole in the guide.
5. Apply the guide to the saloon interior. Overlap the thread studs with the holes. Put the thread studs inside.
6. From the outside of the interior put the washer on the thread stud and tighten it up with a self-locking hex nut.

Securing in place with a screw and a securing plate (all types of guides except S3 and S8)

1. Attach the guide to the installation place of the car saloon interior or the car body.
2. Do the spacing on the saloon interior or the car body through the holes in the guide.
3. Drill the holes for screws according to the made spacing.
4. Put the securing plates with the screws into the guide opposite each hole in the guide.
5. Apply the guide with the screws to the saloon interior or car body. Overlap the screws with the holes in the car body or the saloon interior.
6. Tighten the screws evenly along the full length. Try to keep the alignment while tightening. Try not to damage the guide. The screwdriver is included.

Securing in place with securing plugs (all types of guides)

1. Attach the guide to the installation place of the car saloon interior.
2. Do the spacing on the saloon interior through the holes in the guide.
3. Drill the holes for securing plugs according to the made spacing.
4. Put the securing plugs into the guide opposite each hole.
5. Apply the guide to the saloon interior. Overlap the securing plugs with the holes in the saloon interior. Insert the plugs gently tapping on them.